Image
image
image
image

Mold Removal AZ Offers Mold Sampling AZ, Sample mold mold inspector, What is mold? Molds are simple, microscopic organisms, found virtually everywhere, indoors and outdoors. Molds can be found on plants, foods, dry leaves, and other organic material. Molds are needed for breaking down dead material. Mold spores are very tiny and lightweight, and this allows them to travel through the air. Mold growths can often be seen in the form of discoloration, ranging from white to orange and from green to brown and black. When molds are present in large quantities, they can cause allergic symptoms similar to those caused by plant pollen. Should I be concerned about mold in my home? Yes, if the contamination is extensive. When airborne mold spores are present in large numbers, they can cause allergic reactions, asthma episodes, infections, and other respiratory problems for people. Exposure to high spore levels can cause the development of an allergy to the mold. Mold can also cause structural damage to your home. Similarly, when wood goes through a period of wetting, then drying, it can eventually warp and cause walls to crack or become structurally weak. What does mold need to grow? For mold to grow, it needs: food sources - such as leaves, wood, paper, or dirt a source of moisture a place to grow Can mold become a problem in my home? Yes, if there is moisture available to allow mold to thrive and multiply. The following are sources of indoor moisture that may cause problems: flooding backed-up sewers leaky roofs humidifiers mud or ice dams damp basement or crawl spaces constant plumbing leaks house plants -- watering can generate large amounts of moisture steam from cooking shower/bath steam and leaks wet clothes on indoor drying lines clothes dryers vented indoors combustion appliances (e.g. stoves) not exhausted to the outdoors CAUTION: If you see moisture condensation on the windows or walls, it is also possible that you have a combustion problem in your home. It is important to have sufficient fresh air available for fuel burning appliances, such as the furnace, water heater, stove/range, clothes dryer, as well as a fireplace. A shortage of air for these appliances can result in back drafting of dangerous gases such as carbon monoxide into the home. To prevent back drafting of air, you need either open vents or a ventilation system that brings fresh air into the home to replace air that is exhausted out. Have your local utility company or a professional heating contractor inspect your fuel-burning appliances annually. certified mold testing, Scottsdale, Mold Removal, Mold Inspection, Testing & Detection in Phoenix, Arizona Mold Inspection, mold remediation az, Water Damage, Mold Testing for the Phoenix, Mesa, Scottsdale, Gilbert, Queen Creek and Chandler Areas - Mold in the news, mold testing arizona, mold inspection phoenix, test my home for mold chandler, scottsdale mold testing

 

Welcome


 Envision3 Group, Inc. is a full service Phoenix, Arizona Environmental Firm providing a broad range of environmental consulting including but not limited to mold testing, mold inspections, asbestos inspection, asbestos testing, asbestos management, site assessments, indoor air quality assessments, mold testing, remediation design and implementation, lead based paint inspections and field services to a wide variety of clients. Our personnel are committed to providing prompt and professional environmental services. We pride ourselves on the increasing number of private, corporate, and government clients who exclusively use Envision's services to solve their complex environmental and regulatory concerns.



Our Services:

Asbestos Bulk Sampling

Asbestos Inspection

Mold Testing

Asbestos Final Clearance Air Sampling

Pre-Remediation Mold Testing

Post-Remediation Air Testing

Environmental Design and Project Management

Cost Estimating

Certified Mold Inspectors

Regulatory Compliance

NESHAP Inspections

Expert Witness/Litigation Support

Mold Analysis

Mobile PCM Laboratory

Indoor Air Quality Investigations


Our Mission:

We are a full service Arizona environmental consulting firm founded to enable our clients to respond to their environmental concerns. To achieve this, we have brought together a team of professionals to address our clients individualized issues precisely, responsively, and comprehensively.

To utilize a high degree of professionalism, confidentiality, and integrity toward environmental problem solving and create a successful company with a rewarding work environment that attracts extraordinary environmental professionals, while maintaining a business philosophy that focuses on long-term client relationships based on trust, respect, and efficiency.

By instituting a positive and empowering work atmosphere, we encourage individual and team development. We support team members to contribute to our industry and our community through professional and civic organizations. We believe these are essential elements for responsible and long-term growth.

Integrity is the base from which all our services are carried out. Integrity fosters our pledge to give our clients quality work and cost-effective value. These principles direct our decisions as we build a profitable corporation which reinvests in its future and that of its employees.

MOLD IN THE NEWS

Remove source of mold as soon as possible.
Rosie Romero
Special for The Arizona Republic

Mold is all around us. Some (mushrooms) you can eat, others (penicillin) make you better, but some can make you sick. Although the verdict is still out on some research, there's something we know for sure: Get rid of mold when you find it.

Are all molds dangerous to your health?
No. The human body can tolerate small amounts of mold; high doses are a concern. For the majority of molds, the most common side effects are allergic reactions due to indoor air- quality problems. Reactions range from sneezing or eye irritation to asthma attacks, and can occur in people with or without allergies. Children, elderly and those with impaired immune systems are more susceptible. Symptoms that are non-allergic or -irritant are not commonly reported, according to the Environmental Protection Agency. However, research is ongoing.

Although most molds produce allergens, under certain conditions some can release mycotoxins. In high doses, these can be toxic. In most cases, the amount produced is extremely small.

What else does mold do?
Mold causes damage, even in dry climates like Arizona. This can include an unsightly cosmetic stain or permanent damage to your home. The longer the mold is there, the more damage it will cause.

Where should you look for mold?
Mold is a natural fungus found all over the earth. All types of mold have one thing in common: They need moisture to survive. Some of the most common places to find mold in the home include bathroom (moisture from baths or showers), kitchen (steam from cooking), windows (condensation or bad flashing), attics (from roof leaks), roofs (weather), basements (underground), vents and ductwork (can have condensation and transfers airborne mold spores to other areas of the home) and crawl spaces.

Are there precautions that need to be taken while cleaning mold?
Especially if you have allergies or asthma, it is recommended to stay on the safe side and wear rubber gloves and goggles. A respirator also can be worn while cleaning. If you're working with drywall or wood, remember to treat the area with a proper water sealant after the moisture problem is fixed and the area is clean and mold-free. If the area is over 10 square feet, or if you're concerned with certain health problems, a professional can do the job.

There are concerns that even dead mold spores may be allergenic. Whenever possible, mold must be removed and not just cleaned.

How can you prevent mold?
Many people think that Arizona is immune to mold because of the dry climate, but mold can grow on a wet surface in 48 hours. The sooner the area is cleaned, the better. You must eliminate the moisture source. If you don't, mold will keep reappearing.

Take preventive measures at home.
Occasionally, check areas that are more susceptible to mold growth and get things fixed before much damage occurs. Make sure no sprinklers are hitting the house when they come on, don't use your air-conditioning system if you suspect mold contamination, etc. Additional insulation can prevent condensation on cold surfaces, such as windows, flooring and piping.

Following is an excerptfrom the EPA Mold Website:
Why is mold growing in my home?

Molds are part of the natural environment.  Outdoors, molds play a part in nature by breaking down dead organic matter such as fallen leaves and dead trees, but indoors, mold growth should be avoided.  Molds reproduce by means of tiny spores; the spores are invisible to the non-microscope eye and float through outdoor and indoor air.  Mold may begin growing indoors when mold spores land on surfaces that are wet.  There are many types of mold, and none of them will grow without water or moisture.

Can mold cause health problems?

Molds are usually not a problem indoors, unless mold spores land on a wet or damp spot and begin growing.  Molds have the potential to cause health problems. Molds produce allergens (substances that can cause allergic reactions), irritants, and in some cases, potentially toxic substances (mycotoxins).  Inhaling or touching mold or mold spores may cause allergic reactions in sensitive individuals.  Allergic responses include hay fever-type symptoms, such as sneezing, runny nose, red eyes, and skin rash (dermatitis). Allergic reactions to mold are common.  They can be immediate or delayed.  Molds can also cause asthma attacks in people with asthma who are allergic to mold. In addition, mold exposure can irritate the eyes, skin, nose, throat, and lungs of both mold-allergic and non-allergic people.  Symptoms other than the allergic and irritant types are not commonly reported as a result of inhaling mold.  Research on mold and health effects is ongoing.  This brochure provides a brief overview; it does not describe all potential health effects related to mold exposure. For more detailed information consult a health professional.  You may also wish to consult your state or local health department.

How do I get rid of mold?

It is impossible to get rid of all mold and mold spores indoors; some mold spores will be found floating through the air and in house dust.  The mold spores will not grow if moisture is not present.  Indoor mold growth can and should be prevented or controlled by controlling moisture indoors.  If there is mold growth in your home, you must clean up the mold and fix the water problem.  If you clean up the mold, but don't fix the water problem, then, most likely, the mold problem will come back.

Useful Links:

Centers for Disease Control and Prevention - "Molds in the Environment"

Centers for Disease Control and Prevention - "Questions and Answers on Stachybotrys chartarum and other molds"

Environmental Protection Agency - "Information regarding mold"

Planet Mold (http://www.planetmold.com)

New York City Mold Guidelines

OSHA Indoor Air Quality Guidelines

Environmental Protection Agency / Mold Remediation in Schools and Commercial Buildings

USA Weekend Article (7 21-02) - When Mold Takes Hold

CBS News: An Insidious Mold - The Melinda Ballard Story

AMERICAN ACADEMY OF PEDIATRICS: Toxic Effects of Indoor Molds

Indoor Toxic Molds and their Symptoms By Nachman Brautbar, M.D.

TOXIC MOLD & TORT NEWS

Additional Mold / IAQ Links:

Serving the following areas:

Ahwatukee - Mesa - Chandler - Queen Creek - Apache Junction - Scottsdale - Gold Canyon - Peoria - Glendale - Maricopa - Surprise - Litchfield Park - Goodyear - Sun City - Globe - Sedona - Payson - Tucson - Marana - Casa Grande - Cave Creek - Fountain Hills - Gilbert - Paradise Valley - Buckeye - El Mirage



How am I exposed to indoor molds? 
Mold is found everywhere, indoors and outdoors. It is common to find mold spores in the air of homes and growing on damp surfaces. Much of the mold found indoors comes from outdoor sources. Therefore, everyone is exposed to some mold on a daily basis without evident harm. Mold spores primarily cause health problems when they enter the air and are inhaled in large numbers. People can also be exposed to mold through skin contact and eating. 

How much mold can make me sick? 
It depends. For some people, a relatively small number of mold spores can cause health problems. For other people, it may take many more. The basic rule is, if you can see or smell it, take steps to eliminate the excess moisture, and to cleanup and remove the mold. 

Who is at greater risk when exposed to mold? 
Exposure to mold is not healthy for anyone inside buildings. It is important to quickly identify and correct any moisture sources before health problems develop. The following individuals appear to be at higher risk for adverse health effects of molds: 

Ahwatukee - Anthem - Apache Junction - Arizona City - Avondale - Black Canyon City - Buckeye - Carefree - Cave Creek - Chandler - Desert Hills - El Mirage - Fountain Hills - Gilbert - Glendale - Gold Canyon - Laveen - Litchfield Park - Maricopa - Mesa - New River - Paradise Valley - Peoria - Phoenix - Queen Creek - Rio Verde - Scottsdale - Sun City - Sun Lakes - Surprise - Tempe - Tolleson - Waddell - Youngtown  



EN3G - Defining Environmental Solutions


Contact us | View site map


image


 image
image